Your computer has no monthly limit on hours. Its time is limited only by the usage included in your plan, like your chats.
How it uses your usage
- Time: the computer is charged by the minute while it is running, and the charge counts against the usage included in your plan. In a shared workspace it counts against your own seat. In an Enterprise workspace, where seats include no usage, it is billed as usage within your monthly limit and the workspace's monthly usage ceiling.
- Starts: each time the computer starts, the start is charged too. The page shows how many starts it needed this month and how much of the usage they took, or that they were included at no charge. On a What I did card, the command that started the computer reads Started the computer, with the same information.
- Where to see it: the Your computer page shows this month's computer time and how much of your plan's usage it took. See Check your usage and what happens at a limit.
When the usage runs out, the computer stops. A command that was running still returns the output it had, and the assistant tells you why the work did not finish. Files on the computer are kept. It can start again when your usage resets or when you add extra usage. See What is extra usage?
When it stops by itself
The computer stops when:
- It is idle: it stops a few minutes after its last use (Bluedeer sets how long). A command that is still running counts as use.
- You stop it: with Stop on the Your computer page.
- The usage ran out: the usage included in your plan is used up.
- A scheduled task used its minutes: a scheduled task may use the computer for a limited number of minutes each time it runs, and the computer stops when they are used.
- You no longer have access: you lost your seat in the workspace, or the workspace owner or an admin turned Your computer off. The page says which.
- A problem was found: the page says so, for example when the computer stopped after a problem.
The page shows the reason and when it happened, for example "Stopped by you · 5m ago".
Commands that get stuck or run long
- A long command: the assistant waits for a command for up to 5 minutes. If it needs longer, it continues as a background task and checks on it later. A background task is stopped after a time limit that Bluedeer sets.
- A command with no progress: a running command that has written no output, used no processor time and moved no traffic for a while (Bluedeer sets how long) is stopped, so a command that has hung does not keep the computer running. Its line in What I did reads Stopped: no progress.
- A computer that stops answering: a busy computer that does not answer for a few minutes is stopped. The minutes it did not answer are not charged, and the next command starts it again with its files. The command's line reads Stopped: the computer stopped answering.
When it is under maintenance
Sometimes Your computer is temporarily under maintenance for everyone, because of a problem on Bluedeer's side; it is not something you did. While it lasts:
- The Your computer page says Your computer is under maintenance right now. Try again later.
- Nothing runs on the computer and nothing is charged. A computer that was running when it began is not charged for that time either, and its files stay on it.
- In a chat, the step that needed the computer shows the same sentence, and the assistant tells you so and carries on with what it can do without the computer. A scheduled task that needs the computer ends with the same message and can be run again later.
- Your settings keep what you chose, but you cannot change them until it ends: Members can use their computer, Internet access (where offered), Stop and Keep for another hour on a preview link are shown greyed out, with Computers are under maintenance. You can change this when they are back. Open preview links show that the computer is under maintenance.
It ends by itself: the page shows your computer as usual again within a minute or so, without reloading.